Skip to Content
avatar image
Siva Harish

FIle is not showing in the target directory?

Jun 08, 2017 at 09:17 AM | 106 Views | Last edit Jun 08, 2017 at 09:40 AM 2 rev.

Hi everyone, i created a file to file scenario in pi 7.31 single stack,In sender side i am using FCC every thing is working properly Message ID also generated (i checked in message monitoring there i check the data it is fine) but when i checked in target directory the file is not there .Can any buddy help me out how to resolve this issue?

Thanks,Siva

SAP NetWeaver Process Integration, adapters | SAP Process Integration | sap pi 7.31 | fcc | file to file
Add comment
10|10000 characters needed characters exceeded

  • Follow
  • Get RSS Feed

2 Answers

  • avatar image
    Former Member
    Jun 08, 2017 at 09:54 AM

    Hi Siva,

    Do the comm channel logs of your receiver FCC confirm that the file was written successfully?

    If they do, could it be that there is another process running that is deleting the file or moving it somewhere else (like a managed file transfer service)? Trying to store the file in another directory could help rule out that possibility.

    Regards,

    Patrick

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Jun 08, 2017 at 11:32 AM

    Hi Siva,

    Check your message logs, there might be multiple reasons:

    1. Issue in receiver channel FCC / Issue in message mapping(If mapping is part of design).

    2. Issue in writing Empty files. If your payload is empty and if you need to place the empty file you have to enable the same in receiver channel. If you have enabled option to ignore then you will not see any files created in the target directory.

    3. Check the folder path maintained in receiver channel.

    Share your message log, it will be helpful for us to analyze and help you.

    Thanks-Lokesh

    Add comment
    10|10000 characters needed characters exceeded

    • Iñaki Vila
      Jun 08, 2017 at 12:45 PM

      Hi Siva,

      About the first Lokesh suggestion you should go to the monitoring to the communication channel monitoring and to search your receiver channel and to check any error in the log.

      Regards.