TCODE - IDX5

[Former Member]

Hi all

I ve a doubt about tcode idx5. It is used for idoc monitoring. But wen i give the code in SAP GUI sometines instead of going to the idoc listing page it stays there itself showing : "RFC" at the bottom of the page. Is it coz of ny error?? But after sometime it starts workin again

Thanks

Sumayya

[bhavesh_kantilal · Accepted solution]

hmm.. not sure why you facing this issue. But this can happen when the system is overloaded / has some database level issues.

Check St 22 with user id as * and see if there are any dumps as to why IDX5 errorrs out.

Regards

Bhavesh

[Former Member · Accepted solution]

thanks for the reply......... can you please detail me on this

Thanks

Sumayya

[bhavesh_kantilal · Accepted solution]

You IDX5 is a t code that has a ABAP code running in the background. This would have raised some dumps in the background when you faced the error.

These dumps can be senn in the trasaction ST22. Go to t code St22 , give the appropriate time and make the user id as * and check if there is any dump. If there is what does it state. Contact your Basis team with thsi dump and ask them to take a look at it.

Regards

Bhavesh

[Former Member · Accepted solution]

Thanks a lot for your reply. Some dumps were there. I ve asked them to look at ti.

Thanks

Sumayya

[Former Member]

Hi gurus,

I have seen some dump in the ST22 Tcode and please help me how to find the errors in the IDX5 and how to find the errors in the ST22 .

I have seen the WP index what it states. please tell me.

Thanks and Regards,

Ram.

[Former Member]

Hi,

did yu check it for ST22 and any dump by IDX5 , then you can remove/release .

Also check the below links

http://help.sap.com/saphelp_nw04/helpdata/en/6a/e6194119d8f323e10000000a155106/content.htm

Regards

Chilla