Skip to Content

Conditionally enable SLED/BBD in MIGO

In MIGO, I would like to have the SLED/BBD field open for input for certain company codes only.

OMJX opens it globally. I don't want that. I tried playing with MB_MIGO_BADI but it isn’t relevant.

Is this possible? sled.png

sled.png (11.1 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

2 Answers

  • Jun 07, 2017 at 07:38 PM

    you actually define in OMJ5 in which plant and for what movement type the SLED check is active.

    And even then nothing happens if you have not maintained the minimum shelf life in your material master.

    And if you need further conditional reaction then you get this option through BADI VB_SLED_MANAGEMENT

    Add comment
    10|10000 characters needed characters exceeded

    • Thanks Jürgen

      I was under the impression that VB_SLED_MANAGEMENT is used to influence the calculation. My requirement is to make the screen field SLED/BBD available for user input in MIGO under certain conditions (perhaps if werks or bukrs is a particular value).

      I don't see where that's possible in VB_SLED_MANAGEMENT.

      Do I have that wrong?

  • Jun 07, 2017 at 08:14 PM

    Don't bother about the screen field, this is controlled by the mentioned customizing and your master data. And of course the PO to which you post the receipt should have been created after you made your settings and changed the material master to see the effect.

    Have you seen the documentation in transaction SE18 for BADI VB_SLED_MANAGEMENT ?

    Add comment
    10|10000 characters needed characters exceeded