Hi Experts,
I am doing PI creation based on Activity area. For my activity area, we have lot of storage bins with sectioning (Pallet strategy).
When I select the whole list and click on save it is asking to remove the main bin and PI is possible only for sub bins.
Error log - Item 0000001: Physical inventory only possible for subbins of main bin xxxx.
It is difficult to identify only the main bins and uncheck and it is not acceptable by Business. Could you please advise how to overcome the above issue and it is possible to shows only the subbins directly.
Thanks
Loganathan
Hi,
what type of PI are you creating the document for? Because what I tried: the system is never proposing in my case the main bin if there are sub bins. So I have not managed to create this error.
Brgds
Juergen
---
Want to learn EWM?
Check for EWM courses @ https://training.sap.com/curriculum/scm_ewm
Get a SAP Learning Hub Subscription: https://training.sap.com/shop/learninghub
And it is EWM. NOT eWM - Duh!
Hi Juergen,
Thanks for your response. I was getting the error for both HS and HL procedure.
Regards
Loganathan
With HL (Ad-hoc Physical Inventory (Storage-Bin-Specific) the system gives me a list of ALL bins (which is correct) but no main bin for the one which is seqmented).
With HS (Ad-hoc Physical Inventory (Product-Specific) I only get the bins with material, and only the sub-bins.
So I don't have that problem (note: in the screenshots I have made the selection with the bins, not with the activity area, but the results both time is the same).
If it is not working the same way, it is probably worth to open a ticket for this.
Brgds
Juergen
Somehow I did have screenshots in this, but they are gone, so I have attached them here again.
Hi Juergen,
Thanks for the response. Issue is wrong bin upload. During bin upload, we have loaded the field LGPLA MAIN with the bin name.
After removing the field name from the bin master, it is working fine.
Regards
Loganathan