0PROCESSKEY is not mapped from InfoSource

[Former Member]

Hi,

I see that there are InfoObjects 0BWAPPLNM and 0PROCESSKEY are there from the InfoSource. I see that BWAPPLNM is mapped 0BWAPPLNM but BWVORG is not mapped to anything at all on the BW system.

When I ran RSA3 to see the values for BWAPPLNM and BWVORG from R3, I see the values SD for BWAPPLNM and 101 for BWVORG. However, the data going to BW is transferred but not added to the IC.

Would I have to map BWVORG to some InfoObject from BW side to make this adding records to IC to work?

Thanks.

[Former Member · Accepted solution]

Hi,

Check this post:

Bye

Dinesh

[Former Member · Accepted solution]

Hi,

I checked BF11 and it seemed to have been marked.

What would be the best approach from here if all the settings are marked and checked?

<i>What should I map BWVORG to in this case? Should it be mapped at all?</i>

Thanks

Message was edited by:

Ellen DeGeneres

Message was edited by:

Ellen DeGeneres

[Former Member]

Hi Ellen,

BWVORG should be mapped to 0PROCESSKEY. Check this link from SAP Help on the infosource:

http://help.sap.com/saphelp_nw2004s/helpdata/en/32/26f438151bc321e10000000a11402f/frameset.htm

Bye

Dinesh