on 03-14-2007 3:00 PM
Hi All,
When I run a particular report, all my key figures are coming blank, where as the user is able to see the data, I have SAP_ALL in my profile.
Could you please advise where should I look.
Thanks.
Run the report in RSRT and see.
IN RSRT you can deactivate cache also.
Ravi Thothadri
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Sen,
Where is this ? BeX or a Web report?
also is it a workbook or anything of that sort?
Also check if your macros are enabled...
It cannot be an authorization report - since you would get 'No Authorization' if it was that...
Invalidate the HTTP Cache and also check if the report is running from the OLAp cache opr otherwise... check if any aggregates etc were rolled up properly..
Also is this for all reports or for any one report in particular ?
Arun
Hope it helps...
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Arun,
Thanks for your kind response. I am able to see data in LISTCUBE. Its a Bex report. No workbooks involved. This is for all the reports on this particular cube.
kindly tell me How do I "Invalidate the HTTP Cache and also check if the report is running from the OLAp cache opr otherwise".
Regards.
I would start with LISTCUBE to check if the data you expect is in the cube. You can also go into RSRT and "Execute With Debug" to disable cache, aggregates, etc...
Message was edited by:
Jon H Goldberg
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.