About the microsoft loopback adapter settings

[former_member418094]

In the minisap setup process, when I use the recommended loopback setting and change the ip to 10.10.0.10 and also change the host file.

But If I do this , it's really slow for my minisap to run~~~

So I just change the ip to local host (127.0.0.1)again, then the minisap run much faster?

Would anyone give me some sugestions about how this happened?

[Former Member · Accepted solution]

Hi,

Check below links for information:

<a href="http://www.microsoft.com/technet/prodtechnol/virtualserver/2005/proddocs/vs_operate_using_loopback.mspx?mfr=true">http://www.microsoft.com/technet/prodtechnol/virtualserver/2005/proddocs/vs_operate_using_loopback.mspx?mfr=true</a>

<a href="http://www.kbalertz.com/Feedback.aspx?kbNumber=236869">http://www.kbalertz.com/Feedback.aspx?kbNumber=236869</a>

Regards,

Subhasha Ranjan

Reward points if helpful.

[former_member418094 · Accepted solution]

Hi Subhasha:

I found the related information in the first link you give.

(You can use any Transmission Control Protocol/Internet Protocol (TCP/IP) address, but it is best to choose one from a reserved range of non-routable TCP/IP addresses. For example, TCP/IP addresses of the form 192.168.x.y, where x is a value from 0 through 255 and y is a value from 1 through 254, are non-routable.)

Great thx for your information!