Skip to Content

where is web dynpro for abap

I have access to an ecc5 system but when I go into se80 there is no access to web wynpro for abap. I though t it would just be there!! What system natively has abap web dynpro available?

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Mar 03, 2007 at 01:07 AM

    Hi Ross. ECC 5.0 runs on Netweaver 2004. WebDynpro ABAP was not introduced untill Netweaver 2004s. So really you need to have ECC 6.0 instread of 5.0 in order to leverage WDA.

    And you are right, if you had NW2004s, you could go to SE80, and "WebDynpro Component" would be one of the choices in the drop down list box in the upper left hand corner.

    Regards,

    Rich Heilman

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Mar 05, 2007 at 05:39 AM

    Hi Ross,

    You also need to install WAS 7.0 to run your Web Dynpro Application.

    Cheers,

    Darshna.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Mar 30, 2007 at 04:51 AM

    Hi Ross,

    After installing WAS 7.0, you can't see your UI elements in Layout in Webdynpro ABAP. So for that you need to update your host file and your internet option you need to update advance search. Then only you can be able to design UI. This can be done by your IT Support also. As I faced same problems.

    I hope it will be helpful to you.

    Best Regards,

    Bansidhar

    Add comment
    10|10000 characters needed characters exceeded