on 02-24-2007 9:27 AM
hello all,
while i am loading delta to the cube 0CCA_C11 it was failed,
i request u to plz give me some suggestions how to get that delta to be loaded again,
Points will be allotted .
Thank's in advance
SAP
Hi,
Make the request status to Red from monitor and delete the request from the relevant targets. then go to the delta IP and schedule it. System will prompt you for repeat delta just take it.
Assign points if it helps
Regards,
Srinivas
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
drill down your info cube below tha you can see the info source name(update rules) copy the name and goto info source tab under Modeling search for this info source(it may start with 😎 under this you can find info packs, check which info pack is used to do delta loads to your target, in data targets tab of info pack you can see to whcih target this info source suppling data, use that info pack in update tab of this info pack check the type of update it should be delta update.
Regards
Sankar
Hi,
if every thing fine, use that info pack to load data. r u able to find your info pack??. if not pls check drill drown your info cube where you can see your update rules for that info cube copy the technical name right side name (starts with 😎 -> goto info source screen -> try to search with this name if it appears select the info pack which is supplying delta loads to your data target using that info pack do your delta load. at the time of scheduling it will ask you last delta load was incorrect do you want to repeat again say yes .
Regards
Sankar
thanks a lot
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
80 | |
24 | |
12 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.