Skip to Content
avatar image
Former Member

File Adatper in Sychronous Mode

Hi,

I want to use file adapter in synchronous mode without using BPM.

Can anyone tell me please which method should be used in Advance Mode.

Thanks and Regards,

Sandeep

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • avatar image
    Former Member
    Feb 23, 2007 at 06:50 AM

    Hi ,

    File Adapter does not support synchronous mode of application.You have to use the BPM if you want the response(ie if you are below SP19).

    If you are SP>19...Check this thread...

    File - RFC - File without a BPM - Possible from SP 19.

    Regards,

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 23, 2007 at 06:52 AM
    Add comment
    10|10000 characters needed characters exceeded

  • Feb 23, 2007 at 07:03 AM

    chk this extract that was posted by Bhavesh some time back -

    <i><b>From SP 19 on XI 3.0 and SP 10 on PI 7.0, a File - RFC - File ( Asynch - Synch ) scenario can be done without a BPM.</b>

    Steps:

    Integration Repository

    The Integration Repository will be similar to any Synchronous Scenario ( say HTTP - RFC ) . 1 Outbound Synch message Interface and 1 Inbound Synch Message Interface.

    Integration Directory

    This is where a few differences lie, so let me take some time.

    1. The Receiver Determination , Interface Determination will be the same as in HTTP - RFC synch scenario. Create the Sender File Adapter, Receiver RFC Adapter and Receiver File Adapter.

    2. Sender Agreement will be for the Sender File Adapter. Sender Agreement uses the Synch Outbound Message Interface.

    3. Receiver Agreement will be for the Receiver RFC adapter. Receievr Agreement will use the RFC as thge Inbound Message Interface.

    4. We need to add a few modules in the Sender File Adapter.

    Go to the Modules Tab of the Sender File Adater, and add the following modules in the same sequence,

    Number - ModuleName - Type - ModuleKey

    1- AF_Modules/RequestResponseBean - Local Enterprise Bean - 1

    2- CallSapAdapter-Local Enterprise Bean - 2

    3-AF_Modules/ResponseOnewayBean-3

    Parameters

    ModuleKey - ParameterName - ParameterValue

    1 - passThrough - true

    3-receiverChannel - Receiver File Adapter Name

    3-receiverService - Receiver Business Service/ System

    With this configuration, you can now handle the requirement without a BPM 😊

    This feature been already blogged for JMS Adapters in these blogs ,

    Sync/Async communication in JMS adapter without BPM (SP19)

    Async/Sync Communication using JMS adapter without BPM (SP 19)

    Dynamic Configuration is also possible,and this as well as many other options are discussed in the How To guide - "How To Realize a sync-async and async-sync

    bridge within the Adapter Framework" available on the Service Market Place.

    For info on the Modules used here, look into these links,

    Request Response Bean

    Response Oneway Bean</i>

    It should help you !!!

    Add comment
    10|10000 characters needed characters exceeded