on 02-13-2007 3:21 PM
Hello all,
during performing "Create Connection Between Selected Actions" at Edit Integration Scenario under register card Assign Mapping i am not able to configure Assigned Interface Mapping because of there no selection (Display List of Permitted Values F4) possible. Additional there also "Undefined" comment under Assigned Interface Mapping\Software Component Version.
Interface Mapping and Software Component Version created and activated.
Could you tell me why i can't select any Software Component Version under the connection creation and "Undefined" displayed?
Many Thanks in advanced!
Jochen
Hi Jochen,
Did u assigned the software component to both the system used in Integration scenario.If not assign the software component where the IS is created to both sender and reciever systems
Also make sure that your action is defined as external.We have used IS in development and mapping is working fine.
Hope this will solve your problem.
Thanx & Regards
Vinod
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
HI Jochen,
Please go though any document/blogs which states about any scenario such as File->to->File of else. Here you will find step by step process wich will help you to understand what exactly should be the process and where are you missing out. If you have missed out some step then do it properly and I think your scenario will work fine.
Regards,
Subhasha
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello all,
after deeper investigation i found the cause of this issue.
The receiving message interface was configured as an outbound interface equal the sending message interface. This happened during setup due to the check box is marked for Outbound by default.
After change to Category Inbound at receiving Message Interface it was possible to assign the Interface Mapping for Integration Scenario connection.
Many thanks for support to all!
Jochen
Hi,
Can you check the Outbound and Inbound Message Interfaces again. Is any Interface mapping exist between them and is activated.
The "Undefined" in case of interface mapping is their by default i.e. if nothing is assigned in Interface mapping.
Check this blog for more info.
/people/venkat.donela/blog/2006/02/17/companion-guide-to-integration-scenario
Sachin
Message was edited by:
Sachin Dhingra
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
88 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.