02-12-2007 7:58 AM
hi all,
Is it BASIS job to enable the WAS so ABAPer can do BSP?
Also how do i know if the WAS is enabled?
thanks
William Wilstroth
Message was edited by:
william wilstroth
02-12-2007 8:02 AM
yes it is BASIS job.
to check whether its enabled, if you go to se80, choose bsp application and choose any standard bsp application.
double click on any page and on the right side go to properties tab. at the end you would see the url of the bsp page, if it starts with http://servername.domain.com:......then its enabled.
this weblog may also be of interst to you.
/people/durairaj.athavanraja/blog/2005/08/21/running-your-first-bsp-application-in-sap-netweaver-04-abap-edition--nsp
Regards
Raja
02-12-2007 8:02 AM
yes it is BASIS job.
to check whether its enabled, if you go to se80, choose bsp application and choose any standard bsp application.
double click on any page and on the right side go to properties tab. at the end you would see the url of the bsp page, if it starts with http://servername.domain.com:......then its enabled.
this weblog may also be of interst to you.
/people/durairaj.athavanraja/blog/2005/08/21/running-your-first-bsp-application-in-sap-netweaver-04-abap-edition--nsp
Regards
Raja