Hi SCN,
I am looking to configure GR labels to be output to a specific label printer based on configuration in:
SPRO > MM > IM / Phys. Inv > Output Determination > Printer Determination > Printer Determination by Plant/Stor. Loc./User Group.
I have done the following:
Created a GR condition type for WE Event Type
Assigned Label Type and Label Form keys in the material master
Created a new user groups and have done the assignment in SPRO (as above)
Assigned the 9 print parameter for the GR print condition
Assigned the ND9 parameter in user settings
However the wrong printer is still being triggered during GR......
Any expert thoughts around this will be valued :)
Thanks, Sam :)
show your customizing, the devil is in the details
have you already follow the analysis steps from wiki https://wiki.scn.sap.com/wiki/pages/viewpage.action?pageId=88113280 ?
Hi Jurgen,
Thankyou for your response.
No I've not read that forum in detail, but will do that :)
For now what I can say is, the label does in fact print out successfully but only to a local default Zebra label printer, so probably no need to show customising for that. But please see below customising for output determination by user group and subsequent steps:
1. Printer Determination: SPRO > MM > IM_PI > Output Determination > Printer Determination > Printer Determination by Plant/SLoc/Usr.Grp.
printer-determination-per-plant-sloc-user-group.png
2. Assign Print Parameter 9: SPRO > MM > IM_PI > Output Determination > Maintain Output Types
maintain-output-type-print-parameter-for-zgr1.png
3. Assign ND9 User Parameter (SU01)
Testing has been via the creation and receival of a Purchase Order for Plant 3100 SLoc 3300 to trigger the label output and like I said it has been a successful print but has gone to our printer Zebra_GK420 instead of Zebra_GK420_2 based on the link from the user parameter in user settings.
Please advise if you would like further configuration shots of the Condition Type ZGR1.
Thanks again Jurgen
Sam
can you show a screenshot from the purchase order, just to make sure that it is not by any chance a PO with account assingment
Hi Jurgen,
It turns out our company had a special enhancement in place based on the output device used in MN22 for out Print Condition Record ZGR1.
So assuming this was not in place the above configuration is all correct.
Thanks again for your assistance.
Sam