Skip to Content

Issue in replication of BSEG from ECC to central finance

May 13, 2017 at 05:48 AM


avatar image
Former Member

Hi Experts,

I am new to SLT or replication area.

We are facing an issue while replicating data from SAP ECC(with DMIS 2011_1_7000012) to central finance on SOH 1511. As an initial load we were able to move the data from source system to central finance and this was triggered from central finance SPRO config. As part of the initial load we were trying only BSEG data as we do not have any requirement to move CO data. Data moved for 2016 and April - 2017. But BSEG/BKPF entries for May(which is current period) are not moving to central finance.

Hence we tried to use the replication from LTRC where we selected only BSEG table and triggered the replication but that also did not work.

Note - we have selected write behavior as 3 as it needs to modify the existing entries in destination with the same keys.

In LTRC config we selected the real time and performance optimization settings as well.

But still neither data is getting over to central finance neither it is showing any errors. It shows entries selected when I go to LTRC -> Expert functions -> Display Replication Statistics.

We tried to use some other tables to replicate from replication server to central finance and those were replicated successfully.

Can you guys please guide me on why data for current period did not get inserted as part of initial load triggered from central finance.

And why data is not getting inserted to central finance when replication is executed from LTRC from replication server for BSEG entries( Note - BSEG does not have more entries just couple of thousands and for May it wouldn't be more than 100).

Many thanks in advance.

10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

2 Answers

avatar image
Former Member May 17, 2017 at 08:53 PM

BSEG is Cluster table, we have to select write behavior as 4. Try and let me know, still if you have an issue.

Murali Cheekati

10 |10000 characters needed characters left characters exceeded
Andrey Martynov
May 19, 2017 at 02:54 PM

If the table is in status loaded and no data were transfered into the target, I guess you have filtered out whole data with filter.
Check first are there any data get into filter selection.

Because if the data is selected and don't updated in target you should get the error. At the same time it's wrong tool to check the initial load via replication statistics. For initial load you should check the Load Statistic monitor (the tab right after application log).
The tool that you mentioned contains only the data that was transfered during replication phase.

10 |10000 characters needed characters left characters exceeded