Skip to Content
0

SOAP to RFC scenario - trigger fault message in response

May 10, 2017 at 04:50 PM

46

avatar image

Hi Guys,

I have created an interface for Work order creation in PO which triggers BAPI BAPI_ALM_ORDER_MAINTAIN and returns back the response to the sender. In case of any Mapping exceptions at runtime, the Maximo system at the source is able to capture the fault message generated by the PO system. However, they are not handling the response message. That means in case BAPI returned an error with details, they still treat it as a successful execution. Can I trigger a fault message in case of status code E. I tried to do multi mapping (1:n) in response to populate a Fault message type but it did not work.

Any suggestions would help!

Thanks

10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

2 Answers

Ambrish Mishra May 11, 2017 at 04:06 PM
0

You are right... But it didn't work.

Share
10 |10000 characters needed characters left characters exceeded
Sanjali Salian May 11, 2017 at 03:58 PM
0

Hi Ambrish,

When you say you tried multi-mapping do you mean you had signature similar to this?

Kind Regards
Sanjali


capture.png (18.6 kB)
Share
10 |10000 characters needed characters left characters exceeded