on 05-08-2017 7:19 AM
Dear experts,
We have a scenario where we have to define the cross plant statuses as network for certain material types ? Is there a standard way of achieving this or this can only be done by development..?
Note: We are not using any web based UI
Best regards,
Shashikumar BS
Have you tried? What hinders you to try or what did not work when you tried?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Jurgen,
We have configured cross plant statuses but unable to set a predecessor and successor status for a particular material type.. We wanted to do it standard way with out developing a custom solution for this.. Any suggestions or hints at where can i achieve this in a standard way..
Best regards,
Shashikumar BS
That was not your original question.
There is no predecessor and successor status at all in standard, there is just a variety of status based on your own definition. If you want them in a kind of logic sequence then this is something that needs development and eventually workflow
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
my fault, I understood you wanted to create a status called Network
User | Count |
---|---|
98 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.