German Ü(umlaut) Issue in SAP PI!!

[Former Member]

Hello Every one,

I have problem with German Ü(Umlaut) character issue in receiver IDoc Channel. The character works after mapping step too. But the issue persists after receiver communication channel. Please find the below screenshots of the same.

Input before Mapping:

Mapping Result:

Output after Receiver Channel:

From the above results, The Ü is replaced with . I would request you to kindly help on the same so that I can check from my end.

Thanks in advance for the help!!

Many Thanks,

Best Regards,

Prashanth Bharadwaj Ch.

[former_member190293]

Hi Prashanth!

First of all, do you have the same problem when IDoc is posted in the target system?

Regards, Evgeniy.

[helmut_skolaut3]

I guess the problem is that you pasted into the payload from a text editor with CTRL-C / CTRL-V, right? That is exactly the problem. Please download the original payload to the file system and import into the mapping tool - then the codepage problem will not occur anymore.

If this is not the issue, you should check the sender channel if the payload is correct or not.

If this is not the issue, the receiver channel might have a wrong setup about unicode settings.

[markangelo_dihiansan]

Hi,

Can you execute tcode SNLS in the backend and give us a screenshot?

Regards,

Mark

[Former Member]

Hello Evgeniy Kolmako,

Thank you for the reply. yes in the target system it is replaced with a character #.

Kindly help on the same!!!

Many Thanks,

Best Regards,

Prashanth Bharadwaj Ch.

[Former Member]

Hello Helmut,

Thank you for the help.

Yes the problem is with receiver channel settings. Could you please help me on the same regarding the setting in IDoc receiver so that I can check on the same.

Kindly do the needful.

Many Thanks,

Best Regards,

Prashanth Bharadwaj Ch.