on 01-10-2007 7:10 PM
Hi,
We have installed JDI with DTR, CBS, CMS. Now for the post installation steps, We have used the Template config tool. But the SLD isnt configured. So could you please tell
1. what are the sequence of steps when using DI template in Netweaver Administrator?..
2.Is SLD has to be configured manually?.when should we configure
3. What is the difference between DI template in Netweaver Administrator and Template Config tool?.
Thanks,
Sunita.
can you mention the WAS & EP version that you have installed?
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sunita,
What portal version are you working on?
1. If its EP7 then its recommended not to use Template Configurator..there is a SAP note mentioning this...
But anyways if the Template Config isnt working, you may checking the configurations manually. As per my experience, if the instlaltion was successful, most of the paramters that are mentioned in post installation are set already.
2. Yes, SLD has to be setup manually....we had setup SLD before setting up NWDI
Hope this helps
Warm Regards,
Ritu
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
80 | |
24 | |
11 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.