update rule are indicative.

[Former Member]

Hello

I made transport of a cube and its update rule, I had a code 0, but update rule are indicative.

why and how i can resolve the problem?

Kind regards,

[Former Member · Accepted solution]

Hello

I have again this message and I have checked the update rule and ti’s ok for BW.

IC=TEPRC01 IS=8TEPRO09 error when checking the update rules

Error when activating update rule 8M2L8LCHWLNIK7AXAJ3NX2Y6L

Regards,

[Former Member · Accepted solution]

Check if the SAP Note 893621 applies to your situation ??

[Former Member]

I changed the cube, and I reactivated it, and I also have to reactivate update rules.

i don't andersant why it not activate,

or how i can active the update rule.

[Former Member]

when you make changes to the cube with update rules, they would be deactivated and the last changed would be turned to IMPACT. So you need to reactivate them after any change to the cube.

[former_member188975]

The update rules are inactivated if you make a change to the cube or activate it. Whenever you are transporting a cube, it is a good idea to check the update rules and reactivate them. You can do this by opening up the inactive update rule and clicking the Activate button. The system will prompt for a request (assuming that the update rules have been previously transported) and you can provide the same one that also holds your cube.

Hope this helps...

[former_member188975]

Hi Farchid,

If ou made a change to the cube, or reactivated it, you will also need to reactivate the update rules. Activate the update rules and also transport them.

Hope this helps...