on 01-10-2007 12:41 PM
Dear All
i create a process chain the first step is to load data from PSA into ODS
As i check the log the process finish successfully without any error but autically it does nothing.
'Process started' and 'Process complete' and then 'roll back' , i can't check out the error why it is not loaded into ODS
Thanks for your time
Kind Regards
Terry Ni
Please load data from source to PSA (pack) and then run your chain .. the data should come thru .. if there is no data, DTp would say, process started and finished with no data.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Have you ran an infopackage to transfer the data from the Source System to the PSA? In BI7 the datasource is the PSA so you must transfer the data to the PSA or there is no data to transfer.
SAP recommend you use an InfoPackage to load from Datasource to the PSA and then Transformations/DTP's to the DSO. Once in BI Infopackages are not required.
Hope this helps,
Tom
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Terry,
Have you checked that data was loaded in PSA.i mean is the data available in PSA to load into ODS.?
regards,
Parth.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
81 | |
24 | |
11 | |
9 | |
7 | |
5 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.