Skip to Content
avatar image
Former Member

SAP HANA system copy recovery could not be completed: Invalid size class

Hi,

I am doing homogeneous system copy using HANA backup - recovery method.I did finished complete database backup of my tenant DB.

Now i am trying to install target system using that backup. In my SPM phase "Perform database recovery using backup" it is giving me below error:

Recovery could not be completed: [3020025] Invalid size class <unknown size class 0>.

I try searching everywhere but No luck, Will someone please help.

Add comment
10|10000 characters needed characters exceeded

  • Hello Nishkam,

    Would you mind running the "hdbbackupcheck" on the backup which you have taken just to make sure the backup is not corrupted . If you could send a detailed error log , it would also be of help .

    Regards

    Satish

  • Get RSS Feed

4 Answers

  • avatar image
    Former Member
    May 02, 2017 at 12:51 PM

    Hi,

    Instead of going with manual recovery of HANA DB. you can follow system copy ( homogeneous system copy (SAP HANA - specific Backup/Recovery)) method using SWPM. This will take care of installing new SAP application with HANA DB recovery.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    May 03, 2017 at 12:19 AM

    Hello Rupali,

    Thank you for your message. Actually i am following same ( homogeneous system copy (SAP HANA - specific Backup/Recovery)) method using SWPM.

    In that at phase "Perform database recovery using backup" it is giving me that error.

    Add comment
    10|10000 characters needed characters exceeded

  • May 03, 2017 at 07:12 AM

    Hello Nishkam,

    Would you mind running the "hdbbackupcheck" on the backup which you have taken just to make sure the backup is not corrupted . If you could send a detailed error log , it would also be of help .

    Regards

    Satish

    Add comment
    10|10000 characters needed characters exceeded

  • May 12, 2017 at 05:17 AM

    Hello Nishkam,

    As Satish recommend, please check first SAP Note#1873247 - Checking recoverability with hdbbackupdiag --check and then perform SAP Note#2272121 - How-To: Analyzing Physical Corruptions with the SAP HANA Persistence Diagnosis Tool (hdbpersdiag).

    The indexserver traces can possibly show us, which declaration the corrupted page have and if it's recommended to perform a recovery using a good backup. Also, it could be, that you need to check your I/O layer, because possibly there might be some issue with file system or RAID controller.

    But all this can be analyzed with some additional tests and trace files. The best will be to open a support incident for this issue and provide a full system info dump to the support team, or let the incident assign to my name.

    Add comment
    10|10000 characters needed characters exceeded