on 04-27-2017 1:00 PM
Hello,
We have an infoobject defined as “attribute Only” in Master Data properties tab page “General”.
What are the impacts if we uncheck “Attribute only” flag in other SAP BW objects (infoobject, transfer rules, update rules, DSO, ...) where this infoobject is used?
Thanks in advance,
Fernando Henriques
Hi,
If you uncheck and activate the object again, from then you use these objects in Infocubes. And if these objects already part of DSO's those objects released to reporting.
If the Info object is used in transformation/DTP's, that object will be visible after you uncheck and activate.
-
Regards,
Mgande
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks Mallikarjuna
Hi Fernando,
Checking this property had an impact at a time on the SID generation (SID were not always generated). When unchecking this property, you could then have some issues when these SID are needed (mainly at reporting level).
But this was noted on a 3.0 version. A lot of things may have changed since. If your master data SID table contains already all the needed SIDs, I'm not expected any impact.
Regards,
Frederic
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks Frédéric
User | Count |
---|---|
93 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.