Org Unit Field in IT 0001

[Former Member]

Hi Folks-

The Org Unit field in IT 0001in PA is not capturing the ORG unit stored in OM.Integration is active between OM and PA currently.The Job and position fields are carrying over without any issues.

Used RHINTE30- and the org unit is allready there in Table T527X. What is the solution?

[Former Member]

Hi,

Have you checked the start and end date of your PA0001 record and the OM record.The transfer from OM to PA vice versa is date dependent.It will only be visible when the start and end date match.

With Regards,

Kaustuv Goswami.

[Former Member]

Following thing can happen

1) You might not transferred your org unit from PA to OM. You must run report

RHINTE10 to check integration for all objects be careful about checks inside.

2) To check the consistency of your integration you must run RHINTE20 to create

missing objects

3) Last maintain relation ship with org unit from expert mode fro each org unit.

Nawaz

[Former Member]

are u gettign any error message?u can check table HRP1000 for the org unit and its relations and see if it exists there or not..

give me detailed desription of ur problem

[Former Member]

Hi Amit,

I am not getting any error message. The org unit just comes up as 00000000 on IT0001 in PA. I have checked the hrp10000 and the org unit is there. The integration is fine.The position and the Job ids also carry over-I dont knoe what going on with the Org

[Former Member]

Have U created the relationship between Position and Orgunit.

~BiSu

[Former Member]

Hi,

I got the same prob, and resolved with the following. Replied for general help purpose. As this post is from Dec, hopfully u hv already done.

please do the following steps.

**Go to Tcode SA38

1- Run report RHINTE10

program allows you to create object types in Personnel Administration (HR-PA) which have already been set up in Personnel Planning and Development (HR-PD) and which are needed for integration. dont forget to uncheck "Test" check box.

The following object types are relevant to integration:

PD PA

Work center (object type A) Tables T528B, T528T

Job (Object type C) Tables T513, T513S

Position (Object type S) Tables T528B, T528T

Organizational unit (Object type O) Table T527X

2) Run RHINTE20

This program can be used to check whether the relevant object types for integration have been created in both Personnel Administration (HR-PA) and Personnel Planning and Development (HR-PD).

The entries in the HR tables T513/T513S (job), T528B/T528T (position, work center) and T527X (organizational unit) are compared with the corresponding objects that have been created in the HRPnnnn file for PD in the integration plan version.

Objects that are missing either in PA or PD can be created immediately

3- Also check ur org struct in PPOME. Hope ur prob will b ok with 1st two task

regards,

[Former Member]

Hi,

Try checking the tbale V_T77s0 once again for below integration switches

PLOGI ORGA --> Should be X

PLOGI PLOGI --> Should be 1

PLOGI PERLI --> Should be 99999999

Try to run the below reports once

RHINTE10 uses for integration between OM & PA. (OM should install going for PA)

RHINTE00 uses for integration between PA & OM.(PA should install going for OM)

RHINTE20 uses to run consistency check between OM & PA.

RHINTE30 uses for integration between PD & PA.(PD should install going for PA).

PLOGI feature if it is "X" then it means OM AND PA integrated and vice versa.

Good Luck...!

KK