Skip to Content
0

MRP configuration issue

Apr 25, 2017 at 02:17 PM

54

avatar image
Former Member

Hi Team,

I am configuring MRP for re-order point planning.

As per the requirement, we do not want to implement the MRP at MRP area level but on plant level. Hence in the config node "Activate MRP for MRP area ", the checkbox is not ticked at client level.

However the report RMDBVM00 was executed by mistake. Hence the planning file entries at plant level are converted into MRP area level. (Entries from table MDVM deleted and DBVM updated)

Now when we are running MRP using tcode MD03 or MD02 we are getting error message like "Plant does not exist"

Can someone please assist in analyzing the cause of the issue and the possible resolution.

Regards,

Mitesh Shah

10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

1 Answer

avatar image
Former Member Apr 25, 2017 at 02:30 PM
0

Hi All,

In addition, would like to understand if it is possible to revert the effects of report RMDBVM00 in any way ie After the planning file entries at plant level convert to MRP area level, I need that the planning file entries from MRP area level should again convert to plant level and same should continue in the future.

Regards,

Mitesh Shah

Share
10 |10000 characters needed characters left characters exceeded