Skip to Content

SAP Work Manager TABLE_REFRESH and TABLE_CHECK parameters

Hello all,

We have Work Manager 6.3 and Meter Management 2.1 in a Utility Company.

We need to do a full reload of Complex tables ctLocation and ctEquipment ONLY at first transmit, in order to get all the registers in this tables ( 55,000 functional locations and 27,000 equipment aprox.)

Once we have transmit all the information first time user has been registered, we only need to transmit a delta of data, and never a full reload again.

This is because it takes between 1 and 2 hours to do the full first sync of all data.

So we put the following parameters in Syclo Panel Configuration:

CTLocation:

TABLE_ REFRESH = -1
TABLE_CHECK = 0

CTEquipment

TABLE_REFRESH = -1

TABLE_CHECK = 0

Could this be working fine?

Thank you.


Alvaro

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

0 Answers