Skip to Content
0

RZ10 parameters

Apr 24, 2017 at 09:45 AM

59

avatar image

Hi Gurus,

Recently RAM was upgraded on my Linux - Sybase based ECC 6 EHP 8 system.

Can you please advise which RZ10 parameters I should change to bring this change in-effect?

R..../-

10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

1 Answer

Bartosz Jarkowski Apr 24, 2017 at 10:11 AM
0

Hi,

it all depends how do you manage memory withing SAP environment. Do you configure each parameter indyvidually or rather use Zero Memory Management.

Good start is to firstly check PHYS_MEMSIZE parameter (it should have amount of your RAM memory available on the server - assuming this server works only as SAP Application Server).

Please have a look into following document, it should give you some high level information:

https://www.sap.com/documents/2015/07/10a81ddf-557c-0010-82c7-eda71af511fa.html

Best regards

Bartosz

Share
10 |10000 characters needed characters left characters exceeded