Skip to Content

HANA views activation problem while migrating between Environments.

Hello,

I was trying to migrate the HANA views (AT=attribute, AN=analytic and CA=calculation) from DEV to QA, i have done it through Developer Mode, after moving from DEV to QA, i found that all the views (AT, AN and CA) are inactivated.

The AN Views are showing that AT views that were already attached in data foundation are not available and were shown by a red dot and similar happened with the AN view in CA views.

Can anyone please suggest how to avoid this issue, because it is not possible now to reattach each AT in AN views and AN in CA views, as it contains many calculations and filters.

Please suggest.

Regards

Vaibhav

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Apr 24, 2017 at 12:12 PM

    Thank you guys , I have got the solution.

    What i did , i made a Parent package and put all the sub packages under it, exactly same as i did in DEV.

    Regards

    Vaibhav

    Add comment
    10|10000 characters needed characters exceeded