Skip to Content

Getting blank value when testing the Message Mapping

Hi All,

I am facing a simple problem,

i have to send a field to the target based on the following condition

E1ADRM1-->PARTNER_ID to AHRCFR(targetfield) where E1ADRM1-PARTNER_Q='LF'

I was using equals funcion for checking PARTNER_Q = LF

and PARTNER_ID exists then i am just mapping the both to AND(boolean function)

then used node function createif and mapped to target field ..

But while testing i am getting a blank value...

please suggest u r valuable comments

Regards,

Sridhar

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

3 Answers

  • Best Answer
    avatar image
    Former Member
    Dec 06, 2006 at 11:13 AM

    Hi,

    After boolean AND add a IF node. For true value set PARTNER_ID and map it to target.

    Createif will be used for creating parent nodes.

    Regards,

    Uma

    Add comment
    10|10000 characters needed characters exceeded

  • Dec 06, 2006 at 11:15 AM

    creatif creates just a blank node.

    E1ADRM1-->PARTNER_ID createif-> if E1ADRM1-PARTNER_Q='LF' (true)->map E1ADRM1-PARTNER_Q to target.do that in that order.

    Also, check this blogs.

    /people/sravya.talanki2/blog/2005/08/16/message-mapping-simplified--part-i

    /people/sravya.talanki2/blog/2005/12/08/message-mapping-simplified-150-part-ii

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 06, 2006 at 11:11 AM

    Hi,

    Are you using the function equals that is from boolean category ?

    You have to use the equals function from String category.

    Regards,

    Sudheer.

    Message was edited by:

    sudheer babu

    Add comment
    10|10000 characters needed characters exceeded

    • Hi Sureszh,

      i am using the String equals function only but after that i am using Boolean <b>And</b> function to map the Partner_id to target field if the condition is satisfied..

      Regards,

      sridhar