Skip to Content
avatar image
Former Member

multiple message resend in Runtime workbench

hello experts,

Right now i m facing some problem to resend multiple messages at a time in the Runtime workbench.

If i get too many error message in Runtime workbench -> message monitoring then will anybody tell me that how i can send them at a time?

Please help me out in this case... because it is very difficult for my client to send messages one by one....

Thank you very much.

Regards,

Chaitanya.....

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Dec 01, 2006 at 01:18 PM

    you can resent multiple messages in SXMB_MONI. Select each message you want to resend and hit the restart button. In case of Message monitoring in RWB you can select only one mesg. at a time.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 01, 2006 at 01:23 PM

    HI,

    Through SXMB_MONI also you can only reprocess the errors marked with Red Flags.

    The errors marked with Red Bullets cannot be reprocessed.

    Thanks,

    Tuhin

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 01, 2006 at 01:37 PM

    Hi Chaitanya,

    if you have a closer look in the message monitoring of the rwb.

    on the right side there is a button to enable a multiSelect.

    Hit this button!

    Regards Mario

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Dec 02, 2006 at 04:26 AM

    Hey experts,

    Thanx for quick replies... but the matter is i m getting error in data... so i will not be able to get that message in error into the SXMB_MONI.

    Suppose i have 2 scenarios... 1 related to invoice and 1 related to orders... now the situation is like if order will be present into my receiver system then only it will accept invoice otherwise my invoice message will go into the error... this error i will get into the RWB only. 😔

    so suppose first my invoice message come and it went into the error in RWB... and then order message went into the receiver... so now without change i can resend the message and it will give into the reciever system.....

    so if i have nearly 50-60 msg in error then if i want to resend it once how i can do?

    Hey i hv already tried that multiple selection option but it is allowing me to select multiple messages but it is sending only one message at a time...

    So number of times i have to press resend button.... so please tell me if any other settings are required....

    Thanks in advance...

    Regards,

    Chaitanya.............

    Add comment
    10|10000 characters needed characters exceeded