Skip to Content
avatar image
Former Member

How to permanent register an program for TCPIP RFC

Hi Gurus,

My SAP is installed on Linux and Sybase.

I am trying to permanently register an program for our PO consultant's requirement of an TCP/IP RFC

I am using the following command :

rfcexec -g <gateway_host_fqdn> -x sapgw00 -a <program_name>

This command runs successfully and the TCPIP RFC runs smoothly and I can see the program entry in SMGW --> Logged on clients.

But this command does not bring me back to command prompt and when I kill it using cntrl+c, my TCP/IP RFC stops working and then I do not see that entry in SMGW --> Logged on clients

How do I permanently register this program so that the RFC runs smoothly

Regards

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • avatar image
    Former Member
    Apr 19, 2017 at 11:31 AM

    Hi Sandy

    Is your OS non-windows? Yes, then run the command as

    nohup rfcexec ....... & (nohup at the start and & at the end)

    Also check the below link if that helps

    https://sapbasisbyankur.blogspot.it/2016/08/rfc-connection-between-ecc-and-ep-in-sap.html

    Regards

    Prithviraj

    Add comment
    10|10000 characters needed characters exceeded