on 11-20-2006 3:48 PM
Hi All,
Can I map one of the columns of the table to a different node (value node) from the nodes of the specified table source in the table properties? This table source is a model Node from Adaptive RFC.
regards,
Uma.
Uma,
You can. However, the result may be different:
1. If you are using (value) node that is direct or nested child of your (model) node that is used as table dataSource, then you get unique values per row.
2. If you are using (value) node that is not child of your (model) node that is used as table dataSource, then you same value in every row.
Valery Silaev
SaM Solutions
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Uma, do you want to get the data of a table based on data from multiple nodes?
You can create a new value node, with the columns you want for the table. Fill the data in this node, based on your model output and also on the other node.
Bind datasource of the table to the new node.
OR you can make this field as calculated attribute and calculate the value according to the other value node's data. Either case you need a new value node.
Regards,
LM
Message was edited by:
L Menon
Message was edited by:
L Menon
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
25 | |
12 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.