enable "other combination" button

[purvang_zinzuwadia]

Hi All,

when entering data, to use another combination for selection variable we use "other combination" button. but somehow it got disabled and now i want to change the value of selection variable. so how to enable the button ?

Thanks for help.

[gregor_dieckmann · Accepted solution]

Hi,

I the 'other combinations' button is only enabled if there are 'degrees of freedom' in header combinations, i.e. if after replacement of variables the planning package selection allows more than one header combination.

Example: You use a planning folder and the 'variable container' contains one characteristic with a variable VAR; you maintained possible variables values

var01, var02, var03 in bps0. The characteristic is used in the header of the planning layout. If you now start the planning folder; you are then asked to replace the variable, i.e. you choose e.g. value var02, this means the variable is replaced by value var02 (this is the value the planning package contains at run time) and manual planning will be started with var02 in the header. All other possible values are not known in manual planning.

Set another variable value and press refresh to start manual planning with another variable value.

Regards,

Gregor