on 11-13-2006 3:55 PM
When I create a BSP SAP defaults the URL to http://e10k-d3....:<b>8010</b>; but this URL does not work, and in fact it should be http://e10k-d3....:<b>8000</b>. Can someone tell me how SAP determines what the URL should be and how this is maintained so I can change it to point to 8000 rather than 8010.
Hi,
What you are tyring to change is the port number.
Check transaction <b>SMICM</b> (where you can modify port number until next reboot) and also <b>RZ10/RZ11</b> transaction (but for this, you should rely on your Basis Team !)
The parameter to change is: <i>icm/server_port_xxx</i>
Best regards,
Guillaume
Message was edited by:
Guillaume GARCIA
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Thanks the RZ10 did the trick. It turned out we had incorrectly set up 2 ports.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
85 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.