Skip to Content

ECC job not getting finished even though the records are completely fetched

Hello,

I have a requirement of creating a custom data source using function module with delta enabled. I have created the data source and it is working fine in RSA3 check. I could do Init without data transfer without any issue, but whenever I try to load an init with data transfer or delta loads, all the records are getting extracted, but the ECC job for this is not getting finished. The ECC job will be showing as ACTIVE forever, and due to this my BW infopackage monitor is also not turning to green.

Can anybody tell me what will be the reason for this? Did I missed any code line in my Function Module? Appreciate your support.

Thanks

Renjith

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Apr 05, 2017 at 10:39 AM

    Hi.

    My suggest is to see from SM50 your job running and intercept it from there to see what's going on.

    Hope to help

    Bye

    Add comment
    10|10000 characters needed characters exceeded