on 10-26-2006 2:54 PM
Hello Everyones,
I have an EP 7 which I have installed on a WAS ABAP + JAVA. The Data Soruce configuraion is in dataSourceConfiguration_abap.xml because of this I cannot create any new users in the Portal, can someone tell me how I can change this Config file using the ConfigTool and what procedure is to be used.
Thanks for your help,
John.
Message was edited by: John Bray
Hi John,
See http://help.sap.com/saphelp_nw04/helpdata/en/49/9dd53f779c4e21e10000000a1550b0/frameset.htm for general remarks using this config and see http://help.sap.com/saphelp_nw04/helpdata/en/0f/bdd93f130f9115e10000000a155106/frameset.htm for changing the config.
Hope it helps
Detlev
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi John,
> it possible for me to create users and Groups in the
> Portal which I dont want in the R/3 System
Groups should get created in the Portal UME DB anyhow, see the first link I have provided: "New groups created with the J2EE Engine are created in the Java database." And: "New groups created with the UME are stored in the local database."
Also check out the section "Read-Only and Read-Write Access to the ABAP User Management". Following this, the default is read/write access for creating users. But that (a) might fails in some circumstances or (b) can be switched off.
Also see "Data Source Configuration Files" on help.sap.com - the second given xml -- dataSourceConfiguration_r3.xml -- describes what you want, doesn't it? Be aware that changing from your xml to some other in general is not supported. Also see the SAP notes referenced on help.sap.com.
Hope it helps
Detlev
User | Count |
---|---|
91 | |
10 | |
10 | |
9 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.