Skip to Content
0
Former Member
Oct 19, 2006 at 05:23 PM

Updating Key Figure

18 Views

Hi All,

There is a new unit of measure that was added to our R/3 source system. In order to bring in the new value, I transferred the global settings from the source system in BW.

I could see the new value for the Unit of measure in se16 in the table T006. How ever this new value was not update to any of the key figures like 0UNIT, 0SALES_UNIT etc. This was causing load failures.

I did run the process chain for master data loads but it has not brought in the changes.

Any input to this situation.

Your help is appreciated.

Regards,

S.P

Message was edited by: S.P

Message was edited by: S.P