cancel
Showing results for 
Search instead for 
Did you mean: 

SYSFAIL error SMQ2 during initial load of PLANTs

Former Member
0 Kudos

Hello Everyone,

We are on CRM50 and during the process of the initial download of plants not all plants were replicated. Now we are attempting another load using DNL_PLANT and getting the following error:

Business partner ##1 does not exist. I have not seen this error before and I am not sure how to proceed.

Thanks in advance for your help.

Cheers

Wiktor

Accepted Solutions (1)

Accepted Solutions (1)

Former Member
0 Kudos

I have the feeling the business partner is referring to a organizational entity to which the plant will is assigned. Did you load the sales area's successfully? Tiest.

Former Member
0 Kudos

Hello Tiest,

First thanks for getting back to me. I checked all of the dependent objects and they all loaded clean as in all lights were green in R3AM1. DNL_PLANT was the last object to be loaded and hit this error.

Any other thoughts?

Cheers

Wiktor

Former Member
0 Kudos

Wiktor, I have though about your issue and have seen this error before. The error occurs due to the fact that the BP GUID in R/3 table CRMKUNNR and in the CRM table CRMM_BUT_CUSTNO is not consistent. Have a look at OSS note 522676 and this should take care of your problem. Kind regards, Tiest.

Former Member
0 Kudos

Hello Tiest,

That did not seem to be the issue. I went through and validated the load objects and there was some new configuration in the sales area which I moved over. All other objects loaded correctly.

When I executed DNL_PLANT got:

Not all address numbers have yet been issued.

More confused then before. Any other thoughts?

Thanks for the help!

Cheers

Wiktor

Former Member
0 Kudos

Wiktor, started to think and came to initial conclusion you miht have a number range issue. When looking at OSS I found message 672435 and I do think this will solve your issue. Please check your number ranges for possible overvflows and extend accrdingly. Please assign points as you see fit, Tiest.

Former Member
0 Kudos

Hello Tiest,

Ah, we both came across the same note and I extended he number ranges and all worked.

Thanks for all the help.

Cheers

Wiktor

Answers (0)