Skip to Content
avatar image
Krishnendu Laha

Error during Technical Configuration in CRM Integration with "No Integration" option

Mar 29, 2017 at 08:44 AM | 142 Views

Dear Experts,

we have upgraded our Hybris Marketing System from 1508 to 1702. Now I am doing post activities (manuel) in Technical Configuration (Transaction CUAN_TECHNICAL_CONF).

We do not habe scenario of CRM Integration in our landscape, and I have selected "No Integration" option to run the configuration. But still the error message "Enter an RFC destination to replicate target groups" under group "Activate Adaptor Objects for Replication to SAP CRM" displayed, please find below screen shot:

Actually in my opinion this Step should be skipped when the Scenarion CRM Integration runs with "No Integration" option.

Could you please guide me how to solve the error? it seems there is no SAP Note available.

Thanks,

Krish

crm-integration-error.png (56.3 kB)
SAP Marketing
hybris_marketing_upgrade
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • avatar image
    Axel Semling
    Apr 03, 2017 at 09:33 AM

    Hello Krish,

    only if a CRM integration exits it is required to start the scenario CRM integration. So by running this scenario only CRM relevant tasks are performed, e.g. CRM relevant HANA content is activated. To my knowledge the option "No Integraiton" exists for descoping the CRM Integration.

    Meaning in our case the Hybris Marketing System should run without any errors.

    Best Regards, Axel

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Krishnendu Laha
    Apr 05, 2017 at 10:49 AM

    Hello Axel,

    Thanks for reply. As I mentioned in our scenario, Integration with CRM was not relevant but I wanted to complete the Task with "No Integration" There is no error till date, so all good.

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Oct 18, 2017 at 06:47 AM

    Hi Krishnendu,

    I'm facing the same problem with the "Enter an RFC destinatio to Replicarte target groups".

    How did you solvedit?

    /Kim

    Add comment
    10|10000 characters needed characters exceeded

    • Krishnendu Laha
      Oct 23, 2017 at 02:39 PM

      Hi Kim, we left the error as it is and went on to futher activities. I think it is a Design error and would not do any harm to processes if CRM Integration is not in scope. Thanks, Krish

  • avatar image
    Andrei Vishnevsky
    Feb 01, 2018 at 12:40 PM

    For anyone facing the same issue:

    Change "SAP CRM Deployment" option to something different rather than "No Integration", enter "SAP CRM RFC" as anything but not blank (for example, NONE), switch back to "No Integration".

    Check Run and Configuration Run will be successful.

    Add comment
    10|10000 characters needed characters exceeded