No data from 0FIGL_O06 into 0FIGL_C01

[Former Member]

Hi All,

I'm facing hard time on trying to get data into 0FIGL_C01.

I've already tried direct <b>full load</b> as well as <b>delta load</b> through 0FIGL_O06; none of them works.

When I try delta load, the loading into 0FIGL_O06 works just fine. However when I try to update the infoCube from the ODS, even though the monitor shows green lights (data available for report in the infoCube), no data can be seen in the cube 0FIGL_C01.

Can anybody help me on that one?

Thank you very much,

Claudio

[Former Member · Accepted solution]

Do you see any records in 0FIGL_O06. If so check the update rules has got any filters .. Check your selection from ODS to cube..

Regards

Manga

[Former Member]

Have you tried the new FIGL. 0figl_c10

The new general ledger in SAP ECC5.0 is saved in different tables in the source system.

Kind Regards,

Jaap Paulusse

Atos Consulting

[Former Member]

Hi All,

Thank you guys very much for all that quick help. Analyzing your answers (and realizing that it was not the case) I as able to see I had a problem with master data. It is working now!!!

Again, thank you very much!

PS.: I'm trying to give 2 points for the answers but I got an error message!

Claudiomar

Message was edited by: Claudiomar Cunha

[Former Member]

Hi Cunha.,

What is the problem with master data ?

can u tell us ?

Regards,

Balaji k. Reddy

[Former Member]

Hi Reddy,

I can’t tell you what was the problem for I still don’t know (sorry!!). But what I know is:

When I picked the <i>“<i>Display Data</i>”</i> option for the cube 0FIGL_C01, choosing <i>“Field selection for output”</i>; whenever the field <i>“Company[Company Code”</i> was selected; no data was shown (like if there was no data at all in the Cube".

After realizing that I was able to see data when that field was not selected (the problem was only with that field), I realize I must have problems with “0COMP_CODE” master data.

So, I reloaded the <b>0COMP_CODE</b> master data, loaded the transaction data and everything started to work just fine.

Att.

Claudiomar

[Former Member]

Hi,

Can you run RSRV for your cube and check if there's any error in the cube setup and statistics/indexes? Are the update rules active too?

Cheers,

Gimmo

[Former Member]

When you say you have no data - is that via listcube or via query

If it is via query and you can see the data in listcube - then the read pointer hasn;t moved - so you may need to rollup aggregates

[Former Member]

Hey,

What is your delta update mode?

Make sure you are not running Infopackage with setting: Init without data transfer .

Is your INit proper?

Cheers

Sorabh

• Asign points if it helps**