Skip to Content
avatar image
Former Member

Overhead cost calculations in JVA- Stat. Drilling Ratio

Hi Community,

My understanding of stat. drilling ratio is that one must define the SKF in the JoA and book an SKF to Joint Venture and then run the overhead calculation. I also understand that I should assign a Project Type to the joint venture, in my case I must assign PT01 to my JV. However, I don't how to assign the aforementioned project type to the JV. Any tip of how this can be done is much appreciated.

Regards,

Aloy

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

0 Answers