Integration Repository - Authorization error , unknown username or incorrec

[Former Member]

Hi

I am trying to connect to Integration Repository from t-code "SXMB_IFR" , Its asking for User Name and Password , when i fill in and hit enter i am getting the following message "<u><i><b>Authorization error , unknown username or incorrect password</b></i></u>".

I tried all these options:

1) I am using all roles of user XISUPER

2) Enter Host Name at , C:\WINDOWS\system32\drivers\etc\hosts

3) Refresh the Cache from "Administration Tab"

Any other ideas....

Thank you

Srinivas Vadiguri

[Former Member · Accepted solution]

Hi Srini,

Please check this thread..

cheers,

Prashanth

P.S Please mark helpful answers

[Former Member · Accepted solution]

Prashanth

No Luck , I tried all the steps mentioned in these blogs after connecting to VPN where XI is installed.

What else we can think of?????

I am able connect to ports 8000,50000 but not 50014,50018.

Do you think this is a problem?

Srinivas Vadiguri

[Former Member]

Hi Srinivas,

Why dont u try doing a full cache refresh?? Just might work..

cheers,

Prashanth

P.S Please mark helpful answers

[Former Member]

Prashanth

Now my problem is resolved , I was using wrong IP address , I thought Application server address and host IP address are same but they are different.

The Blog's you sent are very helpful , thank you and i allotted total 8 point to you.

Srinivas Vadiguri

Message was edited by: Srinivas Vadiguri

[Former Member]

Hi Srinivas,

Abhy has also got a valid point there.. Could definitely be a firewall issue too..

cheers,

Prashanth

[Former Member]

Hi Srinivas,

We faced a similar problem. The issue is that the port to which you are trying to access have not been opened for you (firewall issue). So ask ur networking folks to open the ports to allow you access the server.

Preferably ask the to open all the ports between 50000 to 59999.

Regards,

Abhy

[Former Member]

Ports 8000 and 50000 are open , I tested it using Telnet.

Is it required to open all the ports from 50000-59999.

It seems connection is taking place using port 50000.

[Former Member]

Srini,

Do the steps given in this blog...

/people/shabarish.vijayakumar/blog/2006/02/13/unable-to-open-iresrid-xipipi-71-updated-for-pi-71-support

Hope ur problem is resolved...

cheers

Prashanth

P.S Please mark helpful answers

[Former Member]

Prashanth

My Problem is not yet solved but the information/blog which you sent me are very informative and helpful.

Today evening i am going to try it again.

Srinivas Vadiguri

[Former Member]

Hi Srinivas,

Which version of SP are you on?

cheers

Prashanth