Skip to Content

Error during 1:N registration of table EKKO: No registration possible

Facing same issue during configuring, pls. support

Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

4 Answers

  • Mar 17, 2017 at 04:39 PM

    What kind of error do you get? What is the system behaviour?
    Give a more details about problem.

    May be you have a more than 4 configurations from same source that is already replicate tabke EKKO!?

    Kind regards, Andrey

    Add comment
    10|10000 characters needed characters exceeded

  • Mar 20, 2017 at 09:14 AM

    Hi Andrey,

    After adding the table in Table Overview, Failed is setting to 'X' - No logging table created , No Trigger Status is activated.

    View error shows the error message

    Error during 1:N registration of table EKKO: No registration possible

    Add comment
    10|10000 characters needed characters exceeded

    • Did you check how many configurations already replicate table EKKO? If it less as 4, then I can only suggest you to create ticket. Without system access it's pretty difficult to understand what exactly happens

  • Jan 12 at 08:23 AM

    Hi, did you find meanwhile a solution, or do you know, what SAP did?

    BR

    Add comment
    10|10000 characters needed characters exceeded

  • avatar image
    Former Member
    Feb 23 at 03:12 PM

    Hello,

    probably multiple consumers (target systems) are replicating the EKKO table ... or the old replications were not deleted properly.

    only 4 parallel replications are allowed. in source system you can check the number of replications in IUUC_1N_CONS_REG table.

    OSS Note 1933605 helps you to clean the mess after old replications.

    Regards.

    Add comment
    10|10000 characters needed characters exceeded