Skip to Content

Shift & Break times incorrect on Planning Board

Experts,

I have a discrepancy between the data displayed on the Resource Capacity profile & the data shown on the Detailed Scheduling Planning Board.

Capacity profile on the PPDS resource reflects the correct start/end & break timings of shifts (RES01 t-code), however, the same information is skewed while seen on the Planning Board. On the screen prints below, notice how the Shift end shows to be 23:59:59, for 17th March'17 on the Capacity Data of the resource, but ends @ 19:00:00 on the same date in the DS Planning Board.

This resource has been maintained from S4 as an External Capacity. We use S4 1610.

m57px.png (43.4 kB)
47dgl.png (120.9 kB)
Add comment
10|10000 characters needed characters exceeded

  • Get RSS Feed

1 Answer

  • Mar 16, 2017 at 06:40 PM

    On the Planning board, I could find the setting for TIME ZONE, which if I set to the Plant's Time zone, the data displays correctly. Is there a way to pull the time zone data by default & not have to set it on the Planning board? Can it, for example, be pulled from the Location settings or the Routing Time zone data?

    Add comment
    10|10000 characters needed characters exceeded