on 08-12-2006 7:25 PM
We are using Easy Document Management System version 6. The problem is found in below situation:
A new document is created either in Private or Public folder in Easy DMS. A file is attached (ex-text) and when proceed further to save the document the message "RFC system exception:Incorrect parameter type used in an RFC" is poped up. It ends up with short dump. This is happening in case a file is attached.
The error shows in dump:
"Error PARAMETER CONVERSION ERROR occurred. |
| P1=CALL_FUNCTION_ILLEGAL_P_TYPE"
I want to know is there any specific setting to be done for Easy DMS. Could anyone help on this.
Regards,
Velmurugan
There is no setting specific to EasyDMS since this just a frontend. As a starting point, uninstal, reboot and re-instal EasyDMS.
Make sure your document type and storage config are correct and try again.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Arunnachalam,
This is manoj from bangalore, I would like to know about the sap plm training institute's in India, I have vast experience with the windchill plm , i would like to shift to sap plm , please suggest me a good institute.
regards manoj
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
100 | |
12 | |
11 | |
6 | |
6 | |
4 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.