Skip to Content
author's profile photo Former Member
Former Member

Mutex could not be created

Posted on Aug 03, 2006 at 08:27 AM 11 Views

Hi

I am getting a "Mutex could not be created" error.

I have installed the PDK for .Net 2.0 and configured the iViewProcessorService on the portal.

Created a user to start the Portal runtime for .net and assigned the relevant rights to the directories specified in the installation and configuration guide.

I have installed the VS 2003 PDK Add-in and the .Net runtime on my machine. Don't know if I can do that?

Also can't seem to find the "check server" option which I have read about in a couple of the existing posts.

very thanks

Marius

Message was edited by: Marius Koen

SAP NetWeaver
Add comment
10|10000 characters needed characters exceeded

1 Answer

  • author's profile photo Rima Sirich
    Rima Sirich
    Posted on Aug 03, 2006 at 10:23 AM

    Hi Marius,

    1. In which situation you are getting "mutex could not be created" error ? When you are trying to debug ? To run several .net runtime nodes on your machine ?

    2. Regarding "check server" option, which version of the Portal you are using ? EP6 ? NW04 ? Which SP ? Did you deploy com.sap.portal.dotnet.framework.sda after Portal's installation ?

    Regards,

    Rima.

    Add comment
    10|10000 characters needed characters exceeded

    • Rima Sirich Former Member
      Aug 03, 2006 at 11:17 AM

      Hi,

      1. When you are debugging with PDK 2.0, stop .net runtime node. Don't forget to start it again, when you finish to debug.

      2. From your description, I understand that you are running NW04s. If this is the situation, then you will experience problems during working with PDK 2.0 as this version of PDK doesn't support working with NW04s.

      Regards,

      Rima.