Skip to Content
author's profile photo Former Member
Former Member

Print parameters in Job control in LO?

Hi !

Is it mandatory to set Print paramaters in Job Control functon inorder to Transfer the data to Delta Que?

What will be its Impact?

Regards

Durai

Add comment
10|10000 characters needed characters exceeded

3 Answers

  • author's profile photo Former Member
    Former Member
    Posted on Aug 03, 2006 at 05:46 AM

    Hi

    No its not necessary to set the print parameter but you can set it to LOCL printer. Infact that setting will have no effect on delta queue.

    Remember to setup the delta queue if you dont setup then your delta query will be empty and you will have to run the job manually every day which i don't think so any one would like to do it. You can schedule the filling of delta queue as per your data volume requirement and user's requirement of data in biw.

    Hope this helps!!!

    Message was edited by: Sachin Kulshrestha

    Message was edited by: Sachin Kulshrestha

    Add comment
    10|10000 characters needed characters exceeded

  • author's profile photo Former Member
    Former Member
    Posted on Aug 03, 2006 at 05:50 AM

    Hi

    You can give the name of local printer attached with your SAP system and remove the check boxes for New spool request. Then you schedule the control job (delta collector job) to run at daily/weekly etc.

    Regards

    Pradip

    Add comment
    10|10000 characters needed characters exceeded

    • Former Member Former Member

      Hi,

      Refer my previous post..

      also go thru Roberto's web;logs

      /people/sap.user72/blog/2004/12/16/logistic-cockpit-delta-mechanism--episode-one-v3-update-the-145serializer146

      /people/sap.user72/blog/2004/12/23/logistic-cockpit-delta-mechanism--episode-two-v3-update-when-some-problems-can-occur

      /people/sap.user72/blog/2005/01/19/logistic-cockpit-delta-mechanism--episode-three-the-new-update-methods

  • author's profile photo Former Member
    Former Member
    Posted on Aug 03, 2006 at 05:58 AM

    Hi,

    You have to maintain the print parameters in Job control screen in LBWE ,Oherwise it will give u the error msg as 'Error generating job' and you will be not able to create your background job ...

    So,you need to set Print Parameters in Job Control in order to do a V3 job ...

    Add comment
    10|10000 characters needed characters exceeded