Skip to Content
author's profile photo Former Member
Former Member

Problems with Roadmap in VC iView

Hello,

i tried to build a process with VC and we use the wizard (roadmap) to guid the user through simple process steps.

In the storyboard design view of the VC everything seems to be fine. Also the iView (in FLEX) is deployed successful.

When we run the VC iView the roadmap is displayed only with the first three steps - but the roadmap has seven steps. By going over the simple process steps, the steps will shown by reaching the active step. E.g. when we reach step four, this step is shown in the roadmap above.

I have tried to delete and create the layers more then one time but the problem is everytime the same.

Any ideas?

Thanx

Mathias

Add comment
10|10000 characters needed characters exceeded

2 Answers

  • Posted on Aug 01, 2006 at 10:22 AM

    Hi

    If you right click on a layer and then choose configure, do you have an option "Roadmap Steps". If so please change it to "show all steps"

    Jarrod

    Add comment
    10|10000 characters needed characters exceeded

  • author's profile photo Former Member
    Former Member
    Posted on Aug 01, 2006 at 10:25 AM

    Hi,

    thanx for answering, but these option is already marked with "show all steps"

    Any other idea?

    Mathias

    Add comment
    10|10000 characters needed characters exceeded

    • Hi

      You should also check that the line or action joining different layers is set to default, this means that if you have 7 steps, you have 7 lines joining the steps and each one has to be set as default. There is a bug however, that if you have more than 1line from a single layer to other layers, you will not see the steps correctly.