07-12-2006 11:01 AM
hi all,
i've got a Zebra S600. i design a label with Bar-One 'Demo'. i generate a ttf file..., but i cant print.
i need other version of bar-one¿
07-12-2006 11:06 AM
07-12-2006 11:09 AM
Hi Juan,
No the Design software is the same for allmost all the Printers. What is the exact problem you are facing? Could you elaborate on that.
Have you been successfully able to Generate the TTF file and if that is done then copy the TTF file content into your Form which you are using.
Thanks & Regards,
YJR.
07-12-2006 11:15 AM
i print Zebra_demo form well, but if i generate one ttf with a simple variable field dont print.
07-12-2006 12:38 PM
There 'is no need for line
/: NEW-PAGE which are SAPSCRIPT code not ZPL.
May be this cause trouble for printing.
Sincerely
Christophe Blineau
07-12-2006 11:19 AM
i generate this ttf with zebra..
/:NEW-PAGE
/ ^XA
/ DFUB0C32-1FS
/ ^PRC
/ LH0,0FS
/ ^LL400
/ ^MD0
/ ^MNY
/ LH0,0FS
/ FO5,45GB203,0,53FSFO21,57A0N,50,50FRFDSAMPLEFSFO258,165GB203,0,53FSFO274,177A0N,50,50FRFDSAMPLEFSBY3,3.0FO75,51^
= B3N,N,100,Y,NFRFN999^FS
/ FO240,256A0N,37,33CI13FRFN998FS
/ ^XZ
/:NEW-PAGE
/ ^XA
/ ^XFUB0C32-1.ZPL
/ FN999FD&ID_00&^FS
/ FN998FD&ID_01&^FS
/ ^PQ1,0,1,N
/ ^XZ
/ ^FX End of job
i upload it in SAP -SO10, se71- well but dont print :'(
07-12-2006 12:39 PM
Hai Juan
You dont need a Zebra bar one tool for printing graphics from smartforms. You need to have propers
drivers and proper settings in place. Take a look at the OSS notes 750772 - Information on the ZPL-II
printer driver for SmartForms
Check the point 5 in the above oss notes:
5) Support of bitmap graphics
Colored bitmap graphics from SmartForms are changed to black and white when you print
from the LZPL printer driver. If the picture quality is affected by this conversion,
change the graphic to B/W with a graphics program (such as PaintShop Pro), and import
it to SmartForms as as a black and white graphic. Monochrome graphics are not converted
by the driver. However, all graphics may be justified to adjust the size of the graphic
to the printer resolution (203, 300 or 600 dpi).
During the import to SmartForms, you have the option to flag a bitmap as "resident".
In this case, the LZPL printer driver saves the graphic in the RAM of the printer when
it first occurs (Device "R:" of the zebra printer). At the end of the spool request,
the driver deletes the graphic again from the printer's RAM, so that no more memory
remains occupied.
Resident graphics during label printing from SmartForms are therefore only faster
if more than one label is printed within a spool request, and the resident graphic
is repeated on each label.
Regards
Sreeni