No Receiver Determination

[Former Member]

Folks,

I have configured idOC to IDOC and I am getting this error , I have followed all the steps . Still I am getting this error

<i><b>

<SAP:Stack>No receiver could be determined</SAP:Stack>

<SAP:Code area="RCVR_DETERMINATION">NO_RECEIVER_CASE_ASYNC</SAP:Code></b></i>

Regards,

Manish

[moorthy · Accepted solution]

Hi manish,

this error you may get if your Business System used in the Reciever System is not in sync with SLD. Check your Adapter Specific properties for the Reciever Business system is not pointing correctly you get this error.It should point to correct R/3 system

Similar discussion-

Regards,

Moorthy

[Former Member · Accepted solution]

Hi Moorthy,

I have checked my directory objects and are all properly configured. One more thing I am using same receiver communication channel for one more system ( 3.1) and this (3.1) connection as working fine .

manish

[Former Member · Accepted solution]

One more thing in SXMB_MONI Receiver Service tab is void.

[moorthy · Accepted solution]

Generally this problem happens, when the logical system is not pointing to the correct system. anyway adapter speicifc identifiers you have verified right ?

1) Can you check the Reciever Determination ( is the Reciever IDoc Interface is correct..

2) Reciever Agreement

3) Also try to give Sender Service name in the Header Mapping of the Reciever agreement.. And check it.

There is one SAP Note Talking about Reciever Agreement not found- Refer this also-741016

Regards,

Moorthy

[Former Member · Accepted solution]

Hi Moorthy,

I have checked adapter speicifc identifiers and they are pointing to right r/3 systems. I tried to give Sender Service name in the Header Mapping of the Reciever agreementand still it is not working . Do I need to do any settings on Receiver system apart from we20 ?.

MAnihs

[moorthy · Accepted solution]

Hi,

did you check WE20->Inbound Parameters ..( it should have idoc type over there).Also check in IDX1 and IDX2

I don't think so, this scenario has got any of the Logical system errors. anyway check SM58 in XI system.

Also go thru this - just to cross verify-

https://www.sdn.sap.com/irj/servlet/prt/portal/prtroot/docs/library/uuid/cdded790-0201-0010-6db8-beb...

Regards,

Moorthy

[Former Member · Accepted solution]

Hi Manish -

Going back to square 1, check in MONI, within the Inbound Message pipeline step, then within SOAP Header->Main. What is the Sender parameters it lists within the header elements:

<SAP:Sender>

<SAP:Service>Your Sender Service<SAP:Service>

<SAP:Interface namespace="urn:sap-com:document:sap:idoc:messages">Your IDoc</SAP:Interface>

</SAP:Sender>

Double check that you have a receiver determination based on this. If you're using a condition during receiver determination, a bad condition can also cause this error.

Regards,

Jin

[Former Member · Accepted solution]

Hi Moorthy/Jin

I figured out the mistake , I had given FIDCC2.FIDCCP01 idoc type in Mapping and I was assigning FIDCC2.FIDCCP02 in WE20 .

Thanks Guys

Manish