Skip to Content
0

Confusion about Proxy settings in SRM and ECC

Mar 06, 2017 at 05:57 AM

94

avatar image

Hello,

My interface is SAP SRM--PO7.5(java stack)--SAP ECC,

1.am doing PROXY to PROXY Scenario,whether the proxy settings are done in both sides (or) in single side??

2. SAP SRM there is a lot of predefined content is available,am importing those content from SRM to PO in ESR by importing objects and Receiver side is ECC system,In ECC system,how can i develop ESR part?? whether manually created data types,message types and service interfaces or else any other option is there,which is correct way.

could you please help me.

10 |10000 characters needed characters left characters exceeded
* Please Login or Register to Answer, Follow or Comment.

3 Answers

ritu gupta Mar 06, 2017 at 06:41 AM
0

HI Anil,

1--Yes you have to do that on both sides. SRM and PI single stack--1.am doing PROXY to PROXY Scenario,whether the proxy settings are done in both sides (or) in single side??

2---If you are using standard content and your requirement is getting fulfilled then it is okay no need to touch ESR part it not in that case you have to modify the mapping -- SAP SRM there is a lot of predefined content is available,am importing those content from SRM to PO in ESR by importing objects and Receiver side is ECC system,In ECC system,how can i develop ESR part?? whether manually created data types,message types and service interfaces or else any other option is there,which is correct way.

could you please help me.

Share
10 |10000 characters needed characters left characters exceeded
anilkumar reddy Mar 17, 2017 at 11:40 AM
0

Hello Ritu,

Thank you for reply, proxy settings has been done in both SRM and ECC, In PI create two destinations in NWA.one for sender and another for receiver.

In ESR part, downloaded the IR content in sevice market place,so no need to create datatypes,message types and service interfaces.

In ID part, i create communication channel for sender and receiver and ICO.i think configuration part is completed.

SRM persons hitting the messages.but, it is not coming to PI.

where i do mistake,please help me

Regards,

Anil.

Show 1 Share
10 |10000 characters needed characters left characters exceeded

Check the RFC destination in SRM system is it pointing to your PI system ?Do you see any error in SRM systems SXMB_MONI ?

0
anilkumar reddy Mar 20, 2017 at 03:38 AM
0

In SAP SRM system,RFC Destination SAPSLDAPI is it mandatory??

am using PI 7.5 single stack

could you please clarify me.

Share
10 |10000 characters needed characters left characters exceeded